Once you've compromised the outer shell you should be able to easily remove the ring holding the film spool, and then the spool itself. Depending on the film brand, the film is attached to the spool either with a couple "tabs" of film, or just some tape. In the latter case you're going to want some scissors to cut it off. 1. First, turn the Crank-handle all the way in a clock wise motion (toward [1]). 2. Then, wind it all the way in a counter clockwise motion (toward [2]) to charge the shutter. CAUTION: In case of slow shutter speeds (1 sec. to 1/50sec.), make sure the shutter mechanism completes its function before winding the film. Then, set your ISO speed by turning the dial on top of the camera body. Set your focus. Next, select your aperture setting by rotating the ring around your lens barrel. Finally, adjust your shutter speed using either a dial or wheel located on top of the camera body and press down on the shutter button to take a photo. Step 2: Hold a black cloth against the lens to completely obscure it; in contrast, the camera is turned on and linked to the recorder. After that, you’ll hear a “click” as the IR cut is activated because the sensor believes it to be “night time. You should hear another “click” when “night” changes back to “day” when you After applying solvent to the old seal, wait 10-20 seconds and many times with tweezers you can carefully get under the foam seal and get to the tape. Then just peel the entire seal strip off in one piece. Door channel seals vary in width and a custom tool can easily be made to help remove and push the old foam out. Step One: Soften the Adhesive. Turn the hair dryer on its lowest heat setting and heat the screen protector to loosen the glue properly. Be sure to move the hair dryer back and forth and avoid focusing on one area and creating hot spots that can cause screen damage. After all, you will need to get somewhat close enough to soften the glue V6ofz. Posted May 10, 2009.

I did something similar to John's method to remove a corroded battery cover on a Pentax.

.

I drilled two small holes at the end of the coin slot then slipped a finishing nail into each hole. I then slipped a screwdriver between the finishing nails and coaxed the batter cover off. A pin spanner would have been more For the front of the lens, you should avoid rubbing too hard. Use a gentle circular movement to wipe away any dirt. Start from the middle and work outwards, so any dirt is moved away from the central ‘sweet spot’ of the lens. 3. Hot air treatment. With dried-on dirt or stubborn fingerprints a rub alone may not do. Here’s how to do it: 1. First, ensure that your camera is not turned on. You don’t want to take a picture accidentally while taking out the film. 2. Next, locate the film door release. This is usually a small lever or knob on the side of the camera. 3. Once you’ve found the film door release, gently push it in and hold it while you open Step One: Soften the Adhesive. Turn the hair dryer on its lowest heat setting and heat the screen protector to loosen the glue properly. Be sure to move the hair dryer back and forth and avoid focusing on one area and creating hot spots that can cause screen damage. After all, you will need to get somewhat close enough to soften the glue How to Clean the sticky residue off the camera body. I want to use my old Film Camera, but the sticky residue on the body after a long storage period have k Open the film door, and remove the pack. Carefully feel (with just washed and fully dried hands) for the first sheet of film. Slide the dark slide in in front of this first piece of film. Once the slide is fully seated, lights can come back on.

how to remove film from camera